Danfoss Scroll Compressor 3PH R407C R22 PVE Oil Stub Tube - HRP034T4LP6

Danfoss Scroll Compressor 3PH R407C R22 PVE Oil Stub Tube

Part Number: HRP034T4LP6

Danfoss Scroll Compressor 3PH R407C R22 PVE Oil Stub Tube

Part Number: HRP034T4LP6
Danfoss

Sign in to your Aire-Biz account to view pricing and stock levels.

Sign in

Not an Airefrig customer? Complete our online account application form here to apply for a credit account.

  • Danfoss H-Series Scroll Compressors are 100% gas cooled & fitted with an automatic reset line break protector mounted internally on the motor windings. 

    The internal protectors respond to over-current, overheating & are designed to interrupt motor current under a variety of fault conditions such as failure to start, running overload & fan failure etc. 

    If the internal overload protector trips it must cool down to approximately +60 degrees Celsius to reset. (Depending on the ambient temperature this may take up to several hours) 

    Three Phase Sequence & Reverse Rotation Protection 

    The compressor will only operate properly with the correct rotation. If a three phase compressor is wired incorrectly it will run but will have excessive noise, no pressure differential between suction & discharge, plus the suction will become warmer rather than cooler. 

    The smaller range of Danfoss H-Series scroll compressors (up to HLP075) are able to run in reverse rotation safely for up to 150 hours without damaging the compressor, however phase monitors are still recommended. 

    The larger range of Danfoss H-Series scroll compressors (HLP078 onwards) should never be run in reverse. Danfoss recommends phase rotation protection should always be fitted to prevent these compressors from operating in reverse rotation. 

    Single Phase Compressors – Reverse Rotation 

    Brief power interruptions may cause reverse rotation of single phase scroll compressors. The internal protection will stop the compressor & once cooled down will restart with correct rotation. 

    Crankcase heaters are recommended on all stand-alone compressors & split systems. The heater should be energised for a minimum of 12 hours before initial start up (compressor service valves opened) & must remain energised whenever the compressor is off. 

    External High Pressure Switches are required for HCP094,109,120 scroll compressors as these models are not equipped with internal pressure relief valves. 

    Note: Crankcase heater is not supplied with compressor & should be purchased separately if required.

     

  • General Specifications
    Nominal HP2.8 HP
    Displacement8 m³/Hr
    Swept Volume46.21 cm³
    Suction Line ConnectionStub Tube 3/4" ODF
    Discharge Line ConnectionStub Tube 1/2" ODF
    Weight30.42 kg
    Oil Charge1.06 L
    Oil TypePVE Oil 160HV
    Electricsround electrical box with spade terminals
    Electrical Specifications
    Voltage380-415/3/50
    Motor Type3PH
    Max Continuous Current9.5 amps
    Locked Rotor Amps45 amps
    Rated Load Amps6.1 amps
    Crankcase Heater 140watt, 230volt

    1. Crankcase Heaters are not supplied with compressors & should be purchased separately if required

  • ContactorMC12B240V
    Thermal OverloadMT323K10
    Electronic OverloadGMP223P22A
    Crankcase Heater120Z0055
  • danfoss_scroll_dim_1

    Units Dimensions (mm)
    D165
    H413
    H1250
    H2379
  • R22
    Cond Temp (°C)Evaporating Temperature (°C)
    -15-10-5057.210
    45Capacity (w)3693463157407002840290729924
    Input (w)2212216521342113209620882078
    Current (Amps)4.474.324.284.284.254.194.12
    50Capacity (w)3341428553836620798086259447
    Input (w)2485241023582325230422982290
    Current (Amps)4.954.714.624.594.564.524.46
    55Capacity (w)386949716196752981568953
    Input (w)270026202567253425272517
    Current (Amps)5.25.034.974.934.894.85

    Note:

    Rating Conditions 11.1k Superheat, 8.3K Subcooling
    R407C
    Cond Temp (°C)Evaporating Temperature (°C)
    -15-10-5057.210
    45Capacity (w)35464470555968348311905910010
    Input (w)2175216421532138211521002080
    Current (Amps)3.453.433.453.473.483.453.42
    50Capacity (w)3267414051706375777484839386
    Input (w)2459244724372424240423912374
    Current (Amps)3.683.653.663.683.693.673.65
    55Capacity (w)379147625899722178928745
    Input (w)276827582748273227212707
    Current (Amps)3.953.963.994.0143.99

    Note:

    Rating Conditions 11.1k Superheat, 8.3K Subcooling

My Comparison List

Compare Clear all
Sorry, you can only compare products from the same category.